Filter
Top Products
147
Using the Flash
5
Wireless Shooting
Using a Combination of the Built-in Flash and an External Flash
Unit
1 Remove the external flash unit for which the channel was set on the
camera, and place at the desired location.
2 Set the flash mode of the camera to r , and pop up the built-in flash.
3 Confirm that both flashes are fully charged and then take the picture.
Using a Combination of External Flash Units
1 Set the wireless mode of the external flash directly connected to the
camera to [MASTER] or [CONTROL].
2 On the flash connected to another flash unit, set the wireless flash mode
to [SLAVE] and set the channel to the same channel as the camera.
Then, place at the desired location.
3 Confirm that both flashes are fully charged and then take the picture.
HSb (High-speed sync) is not available when the camera is set to discharge
the built-in flash.
MASTER
Discharges both the flash directly connected to the camera and
the flash connected to another flash unit.
CONTROL
The flash directly connected to the camera is discharged as a
test flash only and does not discharge as main flash.
Shake Reduction is not available in Wireless mode.