Filter
Top Products
Operating Instructions
[For assistance, please call: 1-800-272-7033] 67
Over write setting:
Selects [Over Write...] to overwrite the transferred image or [Add
time...] to save each transferred image.
Data transfer method:
Use [Passive Mode] normally. If FTP does not work properly, ask your
ISP or network administrator about the transferring mode of FTP
server. [Passive Mode] or [Active Mode] is available.
b. Mail: Sets the SMTP and POP3 server address*
1
or Host Name*
2
,
Login ID*
2
and Password*
2
.
From (Reply)*
3
: Enter the e-mail address of [Reply-to]. [To] can be the
same address as From (Reply).
To *
3
: Enter the e-mail address of receiver.
Subject & Text *
4
: Sets the subject and text of the e-mail.
Time in 24 h mode is attached on the subject.
Notes
• Set POP3 server address or Host Name, Login ID and
Password if you need POP authentication to send the e-mail.
Ask your ISP or administrator.
• Network Camera will only operate correctly with SMTP (Simple
Mail Transfer Protocol) server. It is not available with Internet-
accessed mail servers like "Hotmail
®
" or other mail accounts
accessed via web browser.
c.
Selects [No Message] or [Mail]
Mail: Only the notification e-mail is sent when the alarm trigger is
active. Refer to b. Mail for each parameter.
*
1
Refer to IP addressing on page 93.
*
2
Refer to unavailable character set 1 on page 93.
*
3
Refer to unavailable character set 2 on page 93.
*
4
Only ["] is unavailable in the ASCII character table on page 93 and
refer to displayable character set on page 94.
2.
Select/Enter the each parameter. Click [Save] when finished.
• Click [Cancel] to quit the current settings. The window returns to Setup
Page without saving the parameters.
• Click [Clear Buffered images] to clear the buffered image.
[Clear Buffered images] does not save the parameters.