Filter
Top Products
Operating Instructions
[For assistance, please call: 1-800-272-7033] 85
3.5.15 Reset to Factory Default
Reset to Factory Default window initializes all the parameters including the ID,
Password, IP address and Subnet Mask except Date and Time setting to the
factory default. Reconfirm the settings before doing the Reset to Factory Default
operation.
1.
Click [Reset to Factory Default] on Setup Page.
2.
Click [Execute].
• Click [Cancel] to quit. The window returns to Setup Page.
Notes
• Do not turn off the power during the Reset to Factory Default. It may
interrupt the Network Camera operation.
• IP address and Subnet Mask should be set again after Resetting to
Factory Default.
• CLEAR SETTING button can also reset Network Camera to the
Factory Default. Refer to page 97.
• Internal clock will not be reset, however, time mode will return to AM/
PM mode and Auto adjustment will be disabled.
• If Reset to Factory Default is used, all user settings will be lost, and you
will have to reconfigure the entire Network Camera.