Filter
Top Products
Operating Instructions
[For assistance, please call: 1-800-272-7033] 73
Over write setting:
Selects [Over Write...] to overwrite the transferred image or [Add
time...] to save each transferred image.
Data transfer method:
Use [Passive Mode] normally. If FTP does not work properly, ask your
ISP or network administrator about the transferring mode of FTP
server. [Passive Mode] or [Active Mode] is available.
b. Mail: Sets the SMTP and POP3 server address*
1
or Host Name*
2
,
Login ID*
2
and Password*
2
.
From (Reply)*
3
: Enter the e-mail address of [Reply-to]. [To] can be the
same address as From (Reply).
To *
3
: Enter the e-mail address of receiver.
Subject & Text *
4
: Sets the subject and text of the e-mail.
Time in 24 h mode is attached on the subject.
Notes
• Set POP3 server address or Host Name, Login ID and
Password if you need POP authentication to send the e-mail.
Ask your ISP or administrator.
• Network Camera will only operate correctly with SMTP (Simple
Mail Transfer Protocol) server. It is not available with the Internet
accessed mail servers like "Hotmail" or others accessed via the web
browser.
*
1
Refer to IP addressing on page 93.
*
2
Refer to unavailable character set 1 on page 93.
*
3
Refer to unavailable character set 2 on page 93.
*
4
Only ["] is unavailable in the ASCII character table on page 93 and
refer to displayable character set on page 94.
2.
Select/Enter the each parameter. Click [Save] when finished.
• Click [Cancel] to quit the current settings. The window returns to Setup
Page without saving the parameters.
• Click [Clear Buffered images] to clear the buffered image.
[Clear Buffered images] does not save the parameters.
Note
Refer to page 42 for the Buffered Image.