Filter
Top Products
Setting up 15
Follow the steps below if your computer has other external
SCSI devices in addition to the DMC camera. You must
install the DMC camera as the last device in your SCSI chain
as follows:
1 Turn off the computer, all SCSI devices, and the camera.
2 Remove the terminator (a) from the last device in your SCSI
chain.
2scsipc.ai
Note: Keep the terminator. You will need to reconnect it if
you wish to use the computer while the camera is
disconnected from it.
3 If necessary for your installation, attach the 25/50 DB to HD
SCSI adapter (b) to the end of the SCSI cable (c).
Use only the cable provided with the camera. Other cables
may appear similar, but could damage the camera or your
computer.
4 Connect the 25/50 DB to HD SCSI adapter (b) to the
connector from which you removed the terminator.
5 If you have not already done so, connect the other end of the
SCSI cable (d) to the SCSI connector on the DMC camera as
shown on page 13.
6 Connect the camera to AC power using the power adapter
(e).
If your PC has other
SCSI devices