Filter
Top Products
62
Playback
CAMERA
VCR
POWER
OFF
AUDIO
DATE/TIME/C
•30•40
TRAC
R/M
REW
RCH
RF
DC OUT
VIDEO
OR
1
VHF Antenna
OR
OR
2
3
2
VHF
VHF
Back of TV
Optional Coaxial
RF Cable
(such as AH065G or AH066G)
Optional RF Output Adapter
(1CVA147C)
Optional
Transformer
(Such as 193983)
IN FROM ANT
Connector
RF Output
Adapter's Plug
CH3/CH4
Switch
Optional
Transformer
(Such as AH011)
VCR/TV Switch
AUDIO, RF DC
OUT, VIDEO
Jacks
OUT TO TV Connector
Playback on a TV Without Audio/Video Inputs
To connect your camcorder to a TV without audio/video inputs, you will need an
optional 1CVA147C RF output adapter and an optional coaxial RF cable, such as
AH065G or AH066G shown on page 66. If your TV has AUDIO and VIDEO IN jacks
(or is connected to a VCR), refer to pages 60-61.
Installation
1 Disconnect the VHF antenna from
your TV. Connect the antenna to the
IN FROM ANT connector on the RF
output adapter if you are going to leave
the adapter connected to the TV.
Note: If your VHF antenna is the flat
twin-lead type attached by two screws,
you will also need an optional 300/75 ohm
transformer, such as 193983 shown on
page 66.
2 Attach one end of the optional coaxial
RF cable to the OUT TO TV connector
on the adapter, and attach the other end
to the VHF input on your TV as
shown.
Note: If your TV has 300 ohm screw
terminals, you will need a 75/300 ohm
transformer, such as AH011, shown on
page 66.
3 Attach the RF output adapter’s plug to
the AUDIO, RF DC OUT, and VIDEO
jacks located under the small cover on
the back of the camcorder.