Filter
Top Products
Advanced Features
78 Chapter 6
Factory Preset: Doesn’t display black bars.
Allows you to record black bars at the top and bottom of
the screen to produce a cinema-like wide-screen effect.
If you take a snapshot in the 16x9 mode, the snapshot is
recorded without the black bars.
Factory preset: Records in S-VHS format on a VHS or S-
VHS tape (see page 23).
Records in S-VHS ET format on a VHS tape (see page 23).
Allows you to set the tape length depending on the tape
used (see page 26).
Factory Preset: Make all of the icons appear on the LCD
monitor/viewfinder during playback or recording.
Make the following icons disappear from the LCD monitor/
viewfinder during recording or playback: cassette warning,
tape remaining time, battery pack remaining power icon
and tape length icon.
Refer to Picture Mode Setting (see page 59).
Displayed when DSC (the DSC indicator is on), is selected
(see pages 60-61).
Refer to Animation and Time-Lapse (see pages 91-92).
Refer to Time-Lapse (see page 92).
Factory preset (OFF) : Usually the distance to a subject
where the lens is in focus depends on the zoom
magnification. Unless there is a distance of more than 1 m
(3.23 ft.) to the subject, the lens is out of focus at the
maximum telephoto setting. When set to ON, you can
shoot a subject as large as possible at a distance of
approximately 60 cm (23-5/8¨).
Depending on the zoom position, the lens may go out of
focus.
16 x 9 OFF
ON
S-VHS *** ON
(S-VHS ET ***) OFF
TAPE LENGTH
DISPLAY FULL
SIMPLE
PICTURE**
SNAPSHOT** FULL
PIN-UP
MULTI-4
MULTI-9
REC TIME*
INT. TIME
TELE MACRO OFF
ON
System Menu (continued)