Filter
Top Products
6. Appendices
50
Section Area (Multi-area Settings)
This function permits the specification of up to four rectangular areas of any size within the
scanning area, each of which can be set as the scanning area. When overlapping areas are set, the
area that was set last takes priority.
For example, when a single original contains both text and photos, specify rectangular areas for
each, and then set binary scanning mode for the text areas and halftone scanning mode for the
photographs. This function allows each area to be scanned in its respective scanning mode in one
scan.
Limitation
❒ During double-sided scanning, this function is valid only for the front side of the original.
Note
❒ Note that scanning might not be performed in the specified manner if any of the four
rectangular areas overlap. In this case, either decrease the number of rectangles, or
else reduce them in size.
❒ This function is valid only when the optional Image Processing Unit Type A is installed.
k
1. Binary scanning is set for the whole page
2. Halftone scanning is set for this area
3. Halftone scanning is set for this area
4. Halftone scanning is set for this area
Original
Result of settings
described above
When entire original
was scanned through
binary scanning
When entire original was
scanned through halftone
scanning
When this function is not used