Filter
Top Products
20
Connecting the Camera to a PC
This section explains how to connect the camera to a PC.
Connecting the Camera to the USB Port
This method is for connecting the camera to the PC using the USB cable.
Important
Note
• Make sure that the USB driver is installed before connecting to a USB
port.
• The flash lamp (red) on the camera blinks while data is being
transmitted. Do not disconnect the cable or turn the camera off while
data is being transmitted between the camera and the PC as the
camera or PC may be adversely affected.
• After connecting the camera to a PC, you are advised to use an AC
adapter when using the camera and avoid powering the camera by the
battery. Particularly if you are handling non-compressed files, motion
pictures or other large files, transmission takes a long time. If the
power fails during transmission, the camera or PC may be adversely
affected.
• Connecting the camera via the USB hub may result in the camera not
functioning properly. If possible, you are advised not to use the USB
hub.
• The camera will not operate on power supplied from the USB port.
■ Connecting the Camera by USB Cable (For Windows)
You can connect the camera to a PC running Windows using the USB cable
supplied with the camera.
A Open the terminal cover on the left
side of the camera.
B Insert the smaller connector on one
end of the USB cable into the
DIGITAL (USB) terminal of the
camera.