Filter
Top Products
Rimage 480i Printer
6 110761_C
2. Lift the ink cartridge latch to the open position.
3. If an ink cartridge is already installed, slide the
ink cartridge out of the ink cartridge cradle.
4. Remove a new ink cartridge from its
packaging and carefully remove the protective
tape that covers the ink nozzles.
- Important Do not touch the nozzles or the
copper contacts on the ink cartridges. If you
touch these parts, clogs, ink failure, and poor
electrical connections are likely to occur. Do
not remove the copper strips.
5. Hold the ink cartridge so that the copper strip
is on the bottom and facing toward the printer
and slide the ink cartridge into the cradle.
Ink cartridge latch
6. Push down on the ink cartridge latch until it snaps closed.
7. Close the Ink Cartridge Access Door. The Ink Cartridge Status light flashes for a few seconds
and then stops flashing.
Note: If the ink cartridge is not securely seated in the cradle, the printer will not recognize
the ink cartridge. The printer may not reset properly or you may receive an “invalid ink
cartridge” message. If this happens:
a. Remove the cartridge and firmly reinsert it.
b. Make sure you are using the appropriate cartridge. Acceptable cartridges are listed in
the Ink requirements
section on page 1.
c. If the problem persists, replace the cartridge.
8. Using the
Aligning the ink cartridges procedure on page 12, align the ink cartridges.