Filter
Top Products
VL-A10H/pp. 008-015; 00/2/2/18:00
G.K. Associates, Tokyo
Preparation
Preparation
9
Charging the Battery Pack
1 Insert the battery pack into the VIEWCAM
(see page 8). Make sure that the Power
switch is set to OFF.
• The battery pack will not charge when the
Power switch is set to CAMERA or VCR.
2 Connect the power cord to the AC adapter,
then insert the AC plug into a power outlet.
3 Open the terminal cover on the VIEWCAM
and insert the DC plug of the AC adapter
into the DC IN jack on the VIEWCAM.
• The CHARGE indicator will light up in red.
4 When the battery is fully charged, the
CHARGE indicator will light up in green.
Remove the DC plug from the VIEWCAM,
and close the terminal cover.
Caution:
• When removing the plugs, grasp the plug, not the
cable.
Charging time and maximum continuous
recording and playback times
Power switch
Terminal cover
Charging
time
Max.
continuous
recording
time
Max.
continuous
playback
time
Battery
pack
DC IN jack
CHARGE indicator
Notes:
• Using the zoom (see page 17) and other
functions or turning the power on and off
frequently will increase power consumption.
This may result in a decrease of more than 50%
in the actual recording time compared to the
maximum continuous recording time listed
above.
• The charging time and recording time may vary
depending on the ambient temperature and the
condition of the battery pack.
• It is recommended that you have enough battery
packs on hand to provide two to three times your
estimated recording time.
• See page 50 for more information on using the
battery pack.
Caution:
• Charge only SHARP model BT-H22 or BT-H32
battery packs. Other types of battery packs may
burst, causing personal injury and damage.
BT-H22
BT-H32
approx.
3 hr.
approx.
6 hr.
approx.
1 hr. 40 min.
approx.
3 hr. 20 min.
approx.
1 hr. 40 min.
approx.
3 hr. 20 min.
To power
outlet