Filter
Top Products
Preparation
Preparation
13
Inserting and Removing a
Card
You can use an SD Memory Card (commer-
cially available) or a MultiMediaCard (only
supplied with VL-NZ10) for storing still images.
Removing a Card
Perform steps 1 and 2 above, push the card
(1) and pull the card straight out (2) as shown
below.
Notes:
• You can use only the SD Memory Card or the
MultiMediaCard (see page 86).
• The MultiMediaCard supplied with VL-NZ10 is
preformatted for immediate use.
• See pages 88 and 89 for more information on the
cards intended for use with this camcorder.
Caution:
• Do not remove the card from the camcorder
while recording data on the card (S indicator
flashes during recording). This may delete the
recorded image or damage the card.
Inserting a Card
1 Make sure that the Power
switch is set to OFF.
2 Slide the card slot cover release and
open the card slot cover in the direction
of the arrow.
3 Insert a card into the slot as shown
below, and push it in as far as it will go.
4 Close the card slot cover.
Card slot cover release
Label
Clipped corner