Filter
Top Products
19
13 Taking Photographs
Switch the camera on and use the Capture / Playback switch to select Capture. Press the Mode
button
as often as necessary until the symbol for photo capture appears at the top left of the
LCD display
.
In the bottom right corner of the display (symbol
), you are shown how many photos you have
already captured, and how many remaining images are available in the current quality.
Press the Capture button
to take a photograph.
13.1 Zoom
When taking photographs, you can zoom in on (magnify) or zoom out from (reduce) your subject.
Push the Navigation button
in the following directions:
c to zoom in (T stands for “telephoto”)
d to zoom out (W stands for “wide angle”)
The right side of the display now shows a graphic, which allows you to find out to what degree you
are currently zooming.
To use the zoom function, the digital zoom must be activated. For more information see “Digital
Zoom“ hapter on page 30.
13.2 Capture Mode
If you are 30 – 40cm away from your subject, you will get a better result by using the
camera in Macro mode. To do this, move the switch
down to the Macro symbol. The
symbol
appears on the left of the camera display when the Macro mode is
activated.
For all other distances, move the switch up to the symbol for normal capture.
13.3 Flash
By pressing the Flash button more than once, you can select various options for the flash. The
following options are available (symbol
):
Flash off: the flash is switched off
A
utomatic flash: the camera uses the light conditions to decide whether or not a flash
is required.
Flash on: The flash is switched on, and is triggered at each capture.