Filter
Top Products
Adjusting and Setting With Menus
SYSTEM Menu
28
VIDEO connector of the camera, and the SDI
OUTPUT connector of an optional BRBK-HD2 Output
Card, if one is installed in a card slot.
SYSTEM Menu
IR-RECEIVE (infrared signal reception)
When it is set to OFF, the camera does not receive the
signal from the supplied Remote Commander.
Be sure to keep it ON when you use the supplied Remote
Commander.
Note
You cannot set IR-RECEIVE to OFF when you operate
the menu using the supplied Remote Commander. To set
it to OFF, use the RM-BR300 Remote Control Unit (not
supplied) or the VISCA command.
IMG-FLIP (image flip)
Set IMG-FLIP to ON to rotate the camera image
supplied from the RGB/COMPONENT connector,
S VIDEO connector, VIDEO connector, and
the SDI OUTPUT connector on an optional BRBK-HD2
Output Card if one is installed in a card slot, upside/
down and to reverse the direction of the camera
movement with pan/tilt operations.
PAN REVERSE: Set to ON to reverse the horizontal
movement of the camera image.
TILT REVERSE: Set to ON to reverse the vertical
movement of the camera image.
When you set IMG-FLIP to ON, “Please restart
system!” appears. Turn off the power of the camera and
turn it on again.
Notes
• Regardless of the IMG-FLIP to ON/OFF setting,
images shot with the camera are accumulated for the
vertical synchronization period and output from the
RGB/COMPONENT connector, S VIDEO
connector, VIDEO connector of the camera, and
the SDI OUTPUT connector on an optional BRBK-
HD2 Output Card, if one is installed in a card slot.
• When you set IMG-FLIP to ON, then turn off the
camera and turn it on again, PAN REVERSE and
TILT REVERSE will be set to ON. When you set
<SYSTEM>
>IR-RECEIVE
IMG-FLIP
PAN REVERSE
TILT REVERSE
DISPLAY INFO
SYNC MASTER
H PHASE
ON
OFF
OFF
OFF
ON
HD
10