Filter
Top Products
Installation and Connections
Installation
43
Installation and Connections
Installation
Attaching an Output Card
Attach an Output Card (not supplied) to the card slot on
the rear of the camera.
1
Loosen the two screws to remove the card slot
cover.
2
Insert an optional Output Card into the card slot.
Align both ends of the Output Card with the sliders
inside the slot, then insert the board securely as far
as it will go.
3
Tighten the two screws on the Output Card.
To remove the Output Card
Loosen the two screws on the Output Card and pull the
board out straight and slowly.
Installing the Camera
To install the camera on a desk
Place the camera on a flat surface.
BRBK-HD2
(not supplied)