Filter
Top Products
56
You can display the frame and check that
the subject is horizontal or vertical by
setting [GUIDEFRAME] to [ON].
The frame is not recorded. Press DISP/
BATT INFO to make the frame disappear.
z Tips
• Positioning the subject at the cross point of the
guide frame makes a balanced composition.
Diagonal stripes appear in portions of the
screen where brightness is at a preset level.
This is useful as a guide when adjusting the
brightness. When you change the default
setting, is displayed. The zebra pattern
is not recorded.
BOFF
The zebra pattern is not displayed.
70
The zebra pattern appears at a screen
brightness level of about 70 IRE.
100
The zebra pattern appears at a screen
brightness level of about 100 IRE or
higher.
b Notes
• Portions of the screen where brightness is about
100 IRE or above may appear overexposed.
z Tips
• IRE represents the screen brightness level.
BAUTO
Displays the remaining recording time of
movies for about 8 seconds in situations
such as those described below.
–When your camcorder recognizes the
remaining hard disk capacity with the
POWER switch is set to (Movie).
–When you press DISP/BATT INFO to
switch the indicator from off to on with
the POWER switch is set to (Movie).
–When you select the movie recording
mode on the HOME MENU.
ON
Always displays the remaining hard disk
indicator.
b Notes
• When the remaining recordable time for movies
is less than 5 minutes, the indicator stays on the
screen.
S
See page 59.
S
See page 59.
GUIDEFRAME
(DCR-SR200/SR300)
ZEBRA
(DCR-SR200/SR300)
REMAINING
FLASH LEVEL
(DCR-SR200/SR300)
REDEYE REDUC
(DCR-SR200/SR300)