Filter
Top Products
84
You cannot charge the battery pack.
• The camera is turned on. Turn the camera off (t step 2 in “Read This First”).
The battery pack cannot be installed.
• Install the battery pack correctly (t step 1 in “Read This First”).
The /CHG lamp flashes when charging a battery pack.
• Install the battery pack correctly (t step 1 in “Read This First”).
• The battery pack is discharged. Re-insert the AC Adaptor and then charge the battery pack.
• The battery pack has malfunctioned. Consult your Sony dealer or local authorized Sony
service facility.
The /CHG lamp does not light up when charging a battery pack.
• The AC Adaptor is disconnected. Properly connect the AC Adaptor (page 16, t step 1 in
“Read This First”).
• Install the battery pack correctly (t step 1 in “Read This First”).
• The battery pack is completely charged.
• The battery pack is discharged. Re-insert the AC Adaptor and then charge the battery pack.
• The AC Adaptor has malfunctioned. Consult your Sony dealer or local authorized Sony
service facility.
• Properly attach the camera to the Cyber-shot Station (page 17).
The battery remaining indicator is incorrect, or sufficient battery remaining
indicator is displayed but the power runs out too quickly.
• This phenomenon occurs when you use the camera in an extremely hot or cold location
(page 99).
• The displayed time remaining differs from the current one. Fully discharge and then charge
the battery pack to correct the display.
• The battery pack is discharged. Install the charged battery pack (t step 1 in “Read This
First”).
• The battery pack is dead (page 99). Replace it with new one.
The battery pack runs down too quickly.
• Charge it sufficiently (t step 1 in “Read This First”).
• You are using the camera in an extremely cold location (page 99).
• The battery terminal is dirty. Clean the battery terminal with a cotton swab, etc., and charge
the battery pack.
• The battery pack is dead (page 99). Replace it with new one.
Battery pack and power