Filter
Top Products
29
Warnings and Indications on the Display Panel
Chapter 2 Locations and Functions of Parts and Controls
g WARNING indicator
This indicator lights up or flashes when there is a fault in
the VTR.
For details, see “8-3 Operation Warnings” on page 127.
h Display panel
This displays VTR-related warnings, battery status, tape
status, audio levels, time data, and so on.
For details, see “2-8 Warnings and Indications on the
Display Panel” on page 29.
i REAR TALLY indicator
When the BACK TALLY switch is set to ON, this indicator
has the same function as the TALLY indicator.
2-8 Warnings and
Indications on the Display
Panel
Tape status, battery status and audio level
Tape status, battery status, and level indicators
Close to end: “TAPE” flashes.
End (tape must be replaced): “TAPE”
and “E” flash.
Audio channel level meter:
When the CH-1/2 / CH-3/4 switch is set
to CH-1/2, the audio channel level 1 is
displayed.
When the CH-1/2 / CH-3/4 switch is set
to CH-3/4, the audio channel level 3 is
displayed.
Audio channel level meter:
When the CH-1/2 / CH-3/4
switch is set to CH-1/2, the
audio channel level 2 is
displayed.
When the CH-1/2 / CH-3/4
switch is set to CH-3/4, the
audio channel level 4 is
displayed.
Nearly dead: “BATT” flashes.
Dead battery (battery must be charged):
“BATT” and “E” flash.
Full (at beginning)
Fully charged
Battery status indicator
Tape status indicator