Filter
Top Products
1-14 (E)
HDCU-900 MM
2. When the turn stops, pull out the remover in the
straight line forcedly.
n
The alignment sleeve can be removed/reinstalled with
the sleeve itself attached to the tip of the remover.
Great care should be taken so as not to lose or damage
the alignment sleeve.
(Alignment sleeve: Sony P/N 9-980-074-01)
3. Clean the tip of the white optical contacts by a cotton
swab moistened with alcohol.
4. Insert the remover with the alignment sleeve attached
to its tip, and push it until it clicks.
5. Rotate the remover counterclockwise to install the
alignment sleeve, and extract the remover.
Connection connector
Clean the optical contact block of the connector using a
cotton swab moistened with alcohol.
Alignment sleeve
Optical contacts (white)
Cleaning
Male connector
Clean the tip of the white optical contacts by a cotton swab
moistened with alcohol.
Female connector
The optical contacts for female connector are in an unex-
posed state. In cleaning, it is necessary to be exposed by
removing the alignment sleeve in advance. Proceed as
follows.
1. Insert the alignment sleeve remover into the alignment
sleeve in the straight line and turn it clockwise.
Optical contacts (white)
Alignment sleeve
Alignment sleeve remover
1-7. Cleaning of Connector/Cable
Optical contact (white)