Filter
Top Products
It is recommended that you adjust the position under actual shooting conditions.
When you attach a lens for which you have already registered a value, the registered
value appears on the screen. [±0] appears for lenses for which a value has not yet been
registered.
If [−] is displayed as the value, then a total of 30 lenses have been registered and no new
lens can be registered. To register a new lens, attach a lens for which the registration can
be erased, and set its value to [±0], or reset the values of all the lenses using [Clear].
If you perform [AF Micro Adj.] with lenses other than Sony, Minolta, or Konica-Minolta
lenses, the registered settings for Sony, Minolta, or Konica-Minolta lenses may be
affected. Do not perform [AF Micro Adj.] with an unsupported lens.
You cannot set [AF Micro Adj.] individually for a Sony, Minolta, and Konica-Minolta lens of
the same specification.
[78] How to Use
Using shooting functions Adjusting the focus
Focus Settings
Sets up the focus functions.
1. MENU → (Camera Settings) → [Focus Settings].
2. Perform settings using the front/rear dial or control wheel.
When the focus mode is set to [Autofocus]/[DMF]
Front dial: Moves the focus area frame up/down.
Rear dial: Moves the focus area frame right/left.
Control wheel: Selects the focus area.
When the focus mode is set to [Manual Focus]
You can set the area to be magnified when focusing manually.
Front dial: Moves the area to be magnified up/down.
Rear dial: Moves the area to be magnified right/left.
Control wheel: Moves the area to be magnified up/down.
Note
You can move the focus area when [Focus Area] is set to the following:
[Zone]
[Flexible Spot]
[Lock-on AF: Zone]
[Lock-on AF: Flexible Spot]