Filter
Top Products
50
Change the Application Setting — Alarm - Motion Detection.
Please follow the steps below to enable changes in the motion detection function of the alarm
through the network if necessary.
Set the motion detection:
1. Click the Motion Detection button on the left side of the Alarm to enter the “Alarm – Motion
Detection” page.
2. Click and drag the left mouse button to across a targeted zone to draw a red rectangle on the
image (coordinates provided below).
NOTE: You can set more than one targeted zone depending on your requirement.
3. Click the right mouse button to see the popup-menu. After setting the target zone, please click
“Save setting”.
4. Enables / disables the motion detection function.
5. Set up the sensitivity.
6. Click the Submit button to submit the new setting of the recording.
7. Click the Home button to return to the home page.
Description of function keys:
The targeted zone: Click and drag the mouse across the targeted zone to draw a red rectangle
on the image.
Detection Range: The red rectangle’s coordinates.
Save: Click to save the motion detection range.
Motion Detection: This option enables / disables the motion detection function.
Sensitivity Level: Selects any one of the given options for the setup signal level.
Submit: Click to submit the new setting to the LAN CAMERA.