Sony MPEG4 LAN Camera Security Camera User Manual


 
6
1/3 inch Sony Super HAD CCD sensor.
MPEG4 resolution (pixels): 640×480, 320x240
Exposure:
Automatic AGC.
White Balance: Indoor installation.
Exposure times: 1/30 -1/27,000s.
Sensitivity:
Minimum Illumination: 0.5 Lux. F1.2
Image:
Image frame rate: up to 25 frames/second.
Supports two compression modes, the Motion-JPEG and the MPEG4.
5 levels of compression provided. The file size of an M -JPEG compressed image
depends on the image’s actual content. Images with a lot of detail will generate bigger
files. The level of compression determines the image quality. High compression requires
smaller files while low compression gives you finer image quality along with bigger files.
The table below contains the average file size in Kbytes, derived from real life tests.
General I/O:
Input/Output connect or to trigger the camera vis-a-vis external events, for instance a
door sensor with a solenoid.
Event triggered remote image storage through e -mail and FTP.
System Requirements:
Compatible with operating systems such as Windows 2000 and Windows XP.
Internet Explorer 6.x.
Non -network modem installation needs Windows PC.
Supported Protocols:
TCP/IP, DHCP, HTTP, UDP, FTP, SMTP, SNTP, ICMP, DDNS, DNS, UPnP
Security:
Password protection available, unless exposure is preferred.
Connections:
RJ 45 twisted p air cable, 10/100 Mbit Ethernet network connection.
Modem connection: RS -232 modem connector for dial-up use. Supports most V90
modems.
Input/Output connector to trigger the camera vis -a-vis external events.
Operating Environment: