Filter
Top Products
9
Getting Started
DCR-PC53E/PC55E 2-548-726-11(1)
7 Install the camcorder onto the
Handycam Station.
Open the interface connector cover.
Place the camcorder on the Handycam
Station properly aligned as shown in
the illustration and gently push down
at the point indicated by the arrow to
fully install.
CHG (charge) lamp
The CHG (charge) lamp lights up and
charging starts.The CHG (charge)
lamp turns off when the battery is fully
charged.
To charge the battery pack using only
the AC Adaptor
Turn off the power, then connect the
AC Adaptor to the DC IN jack on your
camcorder.
• You can operate your camcorder
connected to a power source such as a
wall socket as shown in the illustration.
The battery pack will not lose its charge
in this case.
DC IN jack
DC plug
POWER Switch
Mains lead
AC Adaptor
To the wall socket
Continued