GB
10 Assigning the IP Address to the Camera
1 Using a commercially available
Ethernet cable, connect the
10BASE-T port to a hub in the
network.
Use a UTP Category 5 straight cable for
the connection.
2 Connect the power cord to the
AC power adaptor (both
supplied), and connect the DC
IN 12 V connector of the camera
to an AC outlet.
• To avoid the risk of damaging the data,
turn off the power of the equipment to be
connected before connecting an Ethernet
cable.
• Plug the connectors of the Ethernet cable
fully to the end. A loose connection may
cause noise. To unplug the connector, pull
out by the connector itself.
Connecting the Camera to a
Local Network
AC power adaptor
(supplied)
SNC-VL10P
Power cord
(supplied)
to an
AC outlet
DC IN
12 V
Ethernet cable
(straight, not
supplied)
Hub
Network
10
BASE-T
10BASE-T
Notes