Filter
Top Products
9
GB
Assigning the IP Address to the Camera
Installation and Connections
B Installation and Connections
Assigning the IP
Address to the
Camera
To connect the camera to a network, you
need to assign a new IP address to the
camera.
You can assign the IP address in two ways:
• Using the supplied setup program
• Using the ARP (Address Resolution
Protocol) commands
This section explains how to assign the IP
address using the setup program stored in the
supplied CD-ROM. For this method,
connect the camera to a computer using the
supplied Ethernet cable, or to a local
network using a commercially available
Ethernet cable.
For the use of the ARP command, see the
Operating Instructions stored in the
supplied CD-ROM.
For determining the IP address to be
assigned to the camera, consult your system
administrator.
1 Using the supplied Ethernet
cable (cross), connect the
10BASE-T port of the camera to
the network connector of a
computer.
2 Connect the power cord to the
AC power adaptor (both
supplied), and connect the DC
IN 12 V connector of the camera
to an AC outlet.
Note
Connecting the Camera to a
Computer
AC power adaptor
(supplied)
SNC-VL10P
Power cord
(supplied)
to an AC outlet
DC IN
12 V
Ethernet cable
(cross, supplied)
Network
connector
Computer
10BASE
-T