Filter
Top Products
User’s Manual
DVR-4TN/8TN/16TN/ 16TS/16TT Series
SPECO TECHNOLOGIES 01/06
27
3.6 Record Schedule / Quality Setting
The Record Setup menu allows the user to set recording quality, recording
schedules and other recording parameters. This menu will not be able to
access if you enter the OSD Setup Menu with User’s password. In the Main
menu, move the cursor to <Record Setup> and press ENTER; the following
menu is displayed.
Record Setup
1. Record Mode
2. Schedule Setup
3. Preset Config
4. Per Camera Config
5. ezRecord Setup
6. Data Lifetime
7. Pre-Alarm Recording
8. Circular Recording
9. Audio Recording
10. Purge Data
720×240@60PPS
Standard
0 Days
15 Sec
ON
ON
3.6.1 Record Mode
The Record Mode is for selecting resolution and recording rate. The relative
record settings, such as preset configuration, will follow the record mode
setting. In normal circumstance, we recommend you to select <720 ×
240@60PPS> in NTSC format; or <720×288@50PPS> in PAL format.
Move the cursor to <Record Mode> and press ENTER, then select a Record
mode using the UP / DOWN keys.
NOTE: After changing the Record Mode setting, this warning message
“This will FORMAT ALL HARDDISKS and LOAD THE FACTORY
DEFAULT CONFIG!” will appear on the screen. Press ENTER to
confirm the selection. The unit will then start to format the hard disks
and load the factory default settings, or press ESC to abort.
We strongly recommend that you back up your programmed
configuration before making any changes to Record Mode
settings.