Filter
Top Products
User’s Manual
DVR-4TN/8TN/16TN/ 16TS/16TT Series
SPECO TECHNOLOGIES 01/06
65
- Client IP
This item determines the remote PC’s IP address for connecting with the
DVR-4TN/8TN/16TN/16TS/16TT series unit. To set the Client IP, follow these
steps:
• Select <Client IP>.
• Using LEFT/ RIGHT to move the cursor over the IP, and stop where you
want to make the change.
• Press ENTER, then use UP/ DOWN to change the value.
• When done, press ENTER again to exit.
• Repeat the procedure until the IP is set completely.
- Dial-in Idle Time
This item indicates the longest amount of time that the modem connection
remains active if there is no acknowledgement from the remote pc. The value
can be set from 0 min to 600 min.
- Dial-in Max Time
The item indicates the longest amount of time that the connection via modem
remains active. The value can be set from 0 min to 600 min.
5.1.6.4 Dial-out Setup
The Dial-out function enables the user to establish dial-up modem
communication to and from the DVR-4TN/8TN/16TN/16TS/16TT series unit
for remote notification use. The user can connect one modem to the
DVR-4TN/8TN/16TN/16TS/16TT series unit. For more information for dial-up
setting on PC, see
Appendix D: Dial-up Connections via Modem.
NOTE: The Dial-out Service is not available if there is no modem
connected to the unit.