Filter
Top Products
2
Chapter 2
Basic Setup
This Chapter provides details of installing and configuring the Network Camera.
System Requirements
• To use the wired LAN interface, a standard 10/100BaseT hub or switch and network cable is required.
• To use the Wireless interface, other Wireless devices must be compliant with the IEEE802.11b or IEEE802.11g specifications. All
Wireless stations must use compatible settings.
The default Wireless settings are:
Mode: Infrastructure
SSID: ANY
Wireless Security: Disabled
Domain: USA
Channel No.: Auto
Installation - Network Camera
1. Assemble the Camera
Screw the supplied antenna to the mounting point on the rear.
Attach the Camera Mount to the camera.
2. Connect the LAN Cable
Connect the Network Camera to a 10/100BaseT hub or switch, using a standard LAN cable.
For the Wireless Network Camera, plugging in the LAN cable
will disable the Wireless interface. Only 1 interface can be
active at any time.
The LAN cable should only be connected or disconnected
when the camera is powered OFF. Attaching or detaching the
LAN cable while the camera is powered on does NOT switch
the interface between wired and wireless.
The first time you connect to the camera, you should connect
the LAN cable and configure the Wireless Network Camera
with appropriate settings. Then you can unplug the LAN cable
and power off the camera. The Wireless Network Camera will
be in wireless interface when you power on the camera again.
3. Power Up
Connect the supplied 5Vpower adapter to the Network Camera and power up. Use only the power adapter provided. Using a
different one may cause hardware damage.
5