Filter
Top Products
■
nca(1)
■
snca(1)
■
nca.if(4)
■
ncakmod.conf(4)
■
ncalogd.conf(4)
▼
To Enable SNCA to WorkWith Web Server
This procedure assumes that SNCA has been congured, as discussed above.
From the CommonTasks page, choose aconguration and clickEdit Conguration.
Click the HTTP Listeners taband select the HTTPlistener to edit.
On the Edit HTTP Listener page, setthe Protocol Family tonca.
The HTTP listener must be listening on port 80 for this to work.
Save your changes.
Click the Performance tab.
Click the Cache sub tab.
On the Cache Settings page,make sure the lecache is enabled and enableUse Sendle.
Save your changes.
Redeploy theconguration for your changes to take eect.
Maximum Threads and Queue Size
When conguring Web Server to be used with SNCA, disabling the thread pool provides better
performance. These settings are on the conguration's Performance tab ⇒ HTTP sub tab,
under Thread Pool Settings. To disable the thread pool, deselect the Thread Pool Enabled
checkbox. You can also disable the thread pool using the wadm set-thread-pool-prop
command's enabled property.
The thread pool can also be disabled with non-SNCA congurations, especially for cases in
which short latency responses with no keep-alives must be delivered.
1
2
3
4
5
6
7
8
9
SolarisPlatform-SpecicIssues
SunJavaSystemWebServer7.0Update1 PerformanceTuning,Sizing,and ScalingGuide •92