Filter
Top Products
3-2
SUPERSERVER 5015A-EHF User's Manual
Overheat
When this LED is on it indicates an overheat condition, which may be caused by
cables obstructing the airfl ow in the system or the ambient room temperature being
too warm. Check the routing of the cables and make sure all fans are present and
operating normally. You should also check to make sure that the chassis covers
are installed. Finally, verify that the heatsinks are installed properly (see Chapter
5). This LED will remain on as long as the indicated condition exists.
1
2
NIC2
Indicates network activity on LAN2 when fl ashing .
NIC1
Indicates network activity on LAN1 when fl ashing.
HDD
Channel activity for all HDDs. This light indicates IDE or SATA drive activity when
fl ashing.