Filter
Top Products
5-16
SUPERSERVER 5015A-EHF User's Manual
SMB (I
2
C) Bus to PCI Slots
Jumpers JI
2
C1 and JI
2
C2 allow you
to connect the System Management
Bus (SMB) to the PCI-E PCI slot. The
default setting is Disabled. See table
on the right for jumper settings.
I
2
C to PCI-Slots
Jumper Settings
Jumper Defi nition
On Enabled
Off Disabled
Watch Dog
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset
(default)
Pins 2-3 NMI
Open Disabled
Watch Dog Enable/Disable
Watch Dog (JWD) is a system monitor
that can reboot the system when a
software application hangs. Close pins
1~2 to reset the system if an applica-
tion hangs. Close pins 2~3 to generate
a non-maskable interrupt signal for
the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
the BIOS.
Power Force On Enable/Disable
Jumper JPF allows you to enable or
disable the Power Force On function.
If enabled, the power will always stay
on automatically. If this function is
disabled (the normal setting), the user
needs to press the power button to
power on the system.
Power Force On
Jumper Settings
Jumper Setting Defi nition
Open Normal
Closed Force On
VGA Enable/Disable
JPG1 allows the user to enable the
onboard VGA connector. Close Pins
1~2 to use this function. The default
setting is Enabled.
VGA Enable
Jumper Settings
Pin# Defi nition
1-2 Enabled (default)
2-3 Disabled