Filter
Top Products
Recording
– Basics
23
Recording a picture
Time code
The time code indicates the recording or playback time, “00:00:00:00” (hours : minutes :
seconds : frames). You cannot rewrite only the time code. You can preset the time code.
The time code can be preset or be reset during recording (p. 89). You can select the drop
frame or non-drop frame system using the menu.
On user bits display
You can display the user bits, pressing TC/U-BIT (p. 93).
Remaining tape indicator
The indicator may not be displayed accurately depending on the tape.
Note on the date/time indicator
Recording date/time is not displayed during shooting, however, it is automatically
recorded on the tape. You can check the recording date/time during playback by
pressing DATA CODE. When you want to display the date and time during shooting,
set DATE REC to ON in the menu settings. However, once you record with the date and
time, you cannot erase them.
Shooting backlit subjects (BACK LIGHT)
When you shoot a subject with the light source behind the subject or a subject with a
light background, use the backlight function.
Press BACK LIGHT in standby, recording, or memory mode.
The . indicator appears on the LCD screen or in the viewfinder.
To cancel, press BACK LIGHT again.
If you press SPOT LIGHT when using the backlight function
The backlight function will be canceled and the spot light function will be enabled.
When you manually adjust more than two of the following functions: iris, gain,
and shutter speed
You cannot use the backlight function.
FADER
BACK LIGHT SPOT LIGHT
BACK LIGHT