Filter
Top Products
23
Saddle bracket and footing
on the camera mounting side
Suspension pipe
Anchor bolt for
safety wire
Ceiling panel
1
2
ø50 mm – 60 mm
Camera direction
Suspension plate
Ceiling plate
Paper pattern
C-shaped channel
Suspension plate
Ceiling panel
11.2. Mounting Procedures
1. Determine the suspending position, then make a mounting hole of ø50 – 60 mm in the ceiling plate.
2. Install the anchor bolt for safety wire into the upper ceiling.
Note: If an existing anchor bolt is available nearby, it can be substituted for the anchor bolt for safety wire.
3. Separately prepare a suspension plate, and cut out the necessary hole in a way best suited to the plate
material.
• For strong ceiling materials
• For double-constructed ceilings
4. Detach footings and saddle bracket on the camera mounting side from the suspension pipe.
• Removed saddle brackets and screws are attached to the suspension pipe in step 10.
• Removed footings and screws are attached to the base unit in step 12.