Uniden UDS655 Security Camera User Manual


 
8
Attach the camera
1. For each camera, attach the camera
bracket to the mounting screw. You can
attach the stand to the top or the
bottom of the camera as needed.Tighten
it a few turns, then turn the camera to
face the direction you want.
2. Tighten the camera brace up against the
camera to secure it into place.
3. Unlock the mounting post by turning
the wingnut to the left a few turns.
4. Set the mounting post to the correct
angle, then tighten the wingnut until the
post is locked into place.
5. Attach the antenna to the rear of the
camera.
6. Connect one end of an AC adapter to the camera’s power pigtail and plug the other end into
a 120 volt AC (standard indoor) power outlet. (If necessary, connect the extension cord to the
camera’s pigtail and connect the AC adapter to the extension cord.)
Be sure the power plug and the connector are tightly twisted together to avoid water
leaking in.
7. Make sure the
Power status
light turns on. If it doesn’t, try reconnecting the AC adapter, and
make sure the power outlet isn’t controlled by a wall switch.
Set Up the Monitor
1. Remove the protective plastic from the monitor screen.
2. Flip out the stand on the back of the monitor and extend the antenna.
3. Connect an AC adapter to the power input on the side of the monitor.
1
2
4
3
Loosen the
wingnut to
unlock the
mounting
post.
Attach the camera
to the mounting
screw and turn it
to the desired
direction.
Adjust the post to
the correct angle,
then tighten the
wingnut to lock the
post into place.
Tighten the brace against
the camera to
secure it
in place.