Filter
Top Products
ICA-500 User’s Manual
62/80
Appendix A: Restore Factory
Default Settings
There is a button hidden in the pinhole above the Alarm I/O connector. It is used to
restore the factory default settings. Sometimes restarting the ICA-500 will make the
system back to a normal state. If the system still got problems after reset, user can
restore the factory default settings and install it again.
Restore the ICA-500:
1. Power off the ICA-500.
2. Insert the paper clip or other tool and press and hold the button down
continuously.
3. Power on the ICA-500 again.
4. Wait at least 8 seconds and release the tool. Then the ICA-500 has been
restored to default settings.
Note: Restoring the factory default setting will lose the all-previous settings forever. User
needs to run the IP Finder program to search the ICA-500 and configure it to let the
ICA-500 work properly again.