Filter
Top Products
www.vivotek.com
T: 886-2-22404099
F: 886-2-22404097
14
Power on
Make sure all cables are correctly and firmly connected before turning on NetworKam. Turn on cameras,
sensors, alarm devices, and then attach the power adaptor of NetworKam to the electric power socket*.
After the POST (power-on self test) is complete and the result is successful, NetworKam is ready for
software configuration as described in this manual. At this stage, network speed and video modulation
type are automatically detected. If the detection of video modulation fails, administrators may change the
setting on the configuration page. Refer to the configuration section for further information.
Connect the power jack of the power adapter to NetworKam prior to plugging the utility end into the
utility power socket. It will reduce accidental electric surge shock.