Filter
Top Products
www.vivotek.com
T: 886-2-22404099
F: 886-2-22404097
74
Tel ne t
NetworKam has a Telnet daemon for only administrators to access some seldom used functions. Using
any general terminal program to connect to NetworKam will prompt the user for a password. Username is
not requested here since only administrators can access the Telnet daemon. The password is as same as
that used in web access. After logging in, type "help" for the command list. If "debug" or "dinote" is not
executed, Telnet will disconnect automatically after being idle for 1 minute.
System core debugging
General activities are recorded into SYSTEM.LOG continuously, but information about abnormal status
is not. To look deep into the core debugging information, administrators may type the “debug” command.
This will cause NetworKam to start dumping the detailed debugging information while the system is
running. This is useful to examine if any error has occurred when the system operates abnormally. The
stored information will be cleared automatically after the dump. NetworKam will continue to dump new
messages unless the connection is broken. If Telnet is not connected, any messages will be stored until
administrators re-login.
Monitor changed status of digital inputs
Typing "dinote" will make NetworKam send the current status of all digital inputs. After that NetworKam
will continuously monitor DI status and send messages only when the state has changed. For example,
after typing "dinote" the terminal will display
DI1=L
and after DI2 changes to H, terminal will display
DI1=H
Stop information dumping
Typing "stop" will cease dumping debug information and the digital input status.
Query status of digital inputs
Typing "diquery" will display the status of all digital inputs once.