Filter
Top Products
Installation
Connecting the Power
26
P1021708-001 TTP 2100 Operator Guide 11/04/2009
Connecting the Power
Figure 14 • Location of Power Connector
Using the appropriate Zebra power supply for TTP 2100 Desktop, or Embedded (70W Power
Supply on page 122):
1. Connect the cable from the power supply the power connector on the back of the printer.
2. Connect the power cable to the line outlet.
3. Turn ON the power.
Caution • Using a non-Zebra power supply may cause excessive EMC interferences and
void the EMC certifications of the printer.
Caution • To avoid electrical shock and printer damage, wiring of a non-Zebra power
supply should only be done by qualified service personnel. Use ONLY a power supply
which meets the following minimum requirements:
• 24 VDC ±5%
• 70W average (2.92A) and 284W peak (11.8A) power supply
Caution • On power supplies with line voltage selector, make sure it is set to your local line
voltage.
Power
Connector