Filter
Top Products
Operation
Installing a Paper Roll
32
P1021708-001 TTP 2100 Operator Guide 11/04/2009
Installing a Paper Roll
1. Turn the new paper roll as shown. The paper should be inserted into the printer with the
temperature-sensitive side up so that the paper leaves the roll from the top.
Figure 19 • Installing a Paper Roll
2. Tear off a full turn of the paper from the new paper roll.
Figure 20 • Remove Outer Layer of Paper Roll
3. Make sure the printer is turned ON.
4. Insert the ticket stock through the paper entry opening at the back of the printer.
Caution • This is important since the outer end of the paper is usually fixed to the roll with
some type of glue or self-adhesive substance that might otherwise cause paper jam or
even printhead damage.
Note • The ticket sensor is at the center of the print width. If the ticket edge is torn off in such
a way that the sensor does not see it, auto load will not be triggered. If so, reshape the edge so
that the sensor sees the ticket stock.
Temperature-sensitive
coating
SW96074C
1
SW96075C
2
Glue or similar
substance