Filter
Top Products
27
Installation
Connecting the Power
11/04/2009 TTP 2100 Operator Guide P1021708-001
In kiosk applications you may draw power from a common PSU in the kiosk if the
characteristics are suitable. In such a case, cables that fit the connector on the back of the
TTP 2100 are available from Zebra. If you make cables of your own, connect the voltages
according to the following illustration.
At the printer end of the cable, use a Tyco Mate-N-Lok connector housing and two contact-
sockets.
Figure 15 • Power Connection
Note • Protective ground and minus output should not be interconnected in the power supply.
Table 2 • Current Consumption
Mode 58-60 mm paper width 80 – 82.5 mmpaper width
Idle 150 mA 150 mA
Standard text printing 0.7 A average 1 A average
All black printing 4 A 6 A
GND
+24 V
Housing:
Tyco No. 350777-1
Socket:
Tyco No. 350689-1