Filter
Top Products
VideoJet X20 Configuration Using a Web Browser | en 31
Bosch Security Systems Installation and Operating Manual V3.5 | 2007.12
5.3 Identification
5.3.1 Unit name
You can give the VideoJet X20 a name to make it easier to identify. The name makes the task
of administering multiple units in larger video monitoring systems easier, for example using
the VIDOS or Bosch Video Management System programs.
The unit name is used for the remote identification of a unit, in the event of an alarm for
example. For this reason, enter a name that makes it as easy as possible to quickly identify the
location.
5.3.2 Unit ID
Each VideoJet X20 should be assigned a unique identifier that you can enter here as an
additional means of identification.
5.4 Camera Names
The camera name makes it easier to identify the remote camera location, in the event of an
alarm for example. It will be displayed in the video screen if configured to do so (see
Section 5.5.1 Camera name stamping, page 32). The camera name makes the task of
administering cameras in larger video monitoring systems easier, for example using the VIDOS
or Bosch Video Management System programs.
5.4.1 Camera 1 / Camera 2
Enter a unique, unambiguous name for the camera in this field.
!
CAUTION!
Do not use any special characters, for example &, in the name.
Special characters are not supported by the system's internal recording management and may
therefore result in the Player or Archive Player being unable to play back the recording.
!
CAUTION!
Do not use any special characters, for example &, in the name.
Special characters are not supported by the system's internal recording management and may
therefore result in the Player or Archive Player being unable to play back the recording.