Filter
Top Products
356
If a problem occurs with the camera, first refer to this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem,
contact your dealer or nearest Canon Service Center.
If the battery’s remaining capacity (p.334) is 94% or higher, the
battery will not be recharged.
Do not recharge any battery pack other than genuine Canon
Battery Pack LP-E6.
If (1) the battery charger or battery pack has a problem or (2)
communication with the battery pack failed (with a non-Canon battery
pack), the protection circuit will stop the charging and the lamp will blink in
orange at high speed. In the case of (1), unplug the charger’s power plug
from the power outlet. Detach and reattach the battery pack to the charger.
Wait a few minutes, then reconnect the power plug to the power outlet. If
the problem persists, contact your dealer or nearest Canon Service Center.
If the internal temperature of the battery pack attached to the
charger is high, the charger will not charge the battery for safety
reasons (lamp off). During the charging, if the battery’s
temperature becomes high for any reason, the charging will stop
automatically (lamp blinks). When the battery temperature goes
down, the charging will resume automatically.
Make sure the battery properly is installed in the camera (p.30).
Make sure the battery compartment cover is closed (p.30).
Make sure the card slot cover is closed (p.31).
Recharge the battery (p.28).
Troubleshooting Guide
Power-Related Problems
The battery pack does not recharge.
The charger’s lamp blinks at high speed.
The charger’s lamp does not blink.
The camera does not operate even when the power switch is set to <
1
>.
COPY