Filter
Top Products
136
E
Using a Memory Card
4. Select MIX TYPE.
• CARD CHROMA, CARD LUMI., CAM. CHROMA settings appear.
5. Select the desired setting.
• Your currently recording image is combined with the pre-recorded still
image.
6. Select MIX LEVEL and press the SET button.
7. Adjust the mix level.
• Turning the selector dial upwards adjusts to the right and turning
downwards adjusts to the left.
8. Close the menu.
• CARD MIX flashes in the display.
9. Press the CARD MIX button.
• CARD MIX stops flashing.
• Your currently recording image is combined with the pre-recorded still
image.
• Each time you press the card MIX button, your selection is activated
(display lights continuously) or deactivated (display flashes).
1. Press the start/stop button to start and stop recording.
• The combined images are recorded onto the tape.
1. Press the PHOTO button halfway down and hold it.
• F flashes white in the display as the camcorder adjusts the focus and it is
displayed continuously as a green mark when the camcorder is ready to take
the image.
2. Press the PHOTO button fully down to record the image onto the
tape.
• F disappears from the display.
• The combined images are recorded onto the tape for approximately 6
seconds.
Notes:
• If you change the position of the POWER switch, select your still image for
Card Mix again.
• When setting Card Mix, you must carry out steps 1 to 5.
For stills
For movies
On/Off