Filter
Top Products
69
E
Using the Full
Range of Features
Audio Recording
To switch to the 16-bit mode, open the menu and select VCR SET UP.
Then select AUDIO MODE, set it to “16 bit” and close the menu.
• “16 bit” is shown in the display for approximately 4 seconds.
Notes:
• For details on adding new sound, see p. 95.
• For details of playing back a tape that has new sound on stereo 2, see p. 98.
• When you record to the ELURA50 from a camcorder with DV terminal
outputs, the audio mode becomes automatically set to 12 bit.
• In TAPE PLAY (VCR) mode, the audio mode takes effect when doing analog
line-in recording or AV insert. When you do DV in recording, the setting
automatically changes to that of the digital device connected to the camcorder.
Selecting the audio mode
The camcorder can record sound on a tape in two audio modes — 16-bit and 12-
bit. The 16-bit mode produces the higher sound quality (slightly superior to CD)
while the 12-bit mode records on two channels (stereo 1), leaving 2 channels free
(stereo 2) for you to add new sound at a later time.
AUDIO MODE••12bit
VCR SET UP
( 39)
External microphone
+
,
+
PLAY
(VCR)
TAPE
CAMERA
TAPE
For greater creative control over audio recording, you can connect an external
microphone to the camcorder via the MIC terminal. When using the MIC
terminal, use a microphone with a built-in power supply (condenser microphone).
It is possible to connect almost any stereo microphone with a plug diameter of
0.14 inch (3.5 mm), however, their audio levels will be different from that of the
built-in microphone.
Attach the microphone to the optional SA-1 Adapter Bracket.