Filter
Top Products
2.Edit Exposure Mode Settings
– 10 –
2.3 Setting DWT DEP Tab
2.3.1 Setting DWT DEP for High-Density Field
1
Set the DWT DEP for the High-Density Field effective
Touch [HIGH DENS.] to display the parameters. The appearance of the button switches
over between the highlight (in white outline characters against a colored background)
and normal display each time you touch the button. The parameters are available when
the button is highlighted.
DWT DEP Screen with Parameters of HIGH DENS.
2
Set the STARTING DENSITY parameter of the High-Density Field
Touch the or button, and set the value within the range between 0 to 30.
If the parameters of the Low-Density Field are effective, this value cannot be set lower
than the value of STARTING DENSITY of the Low-Density Field (→ P.12).
The value on the left is the setting saved previously, and the value on the right is the cur-
rent setting.
The value indicates the lower limit of density to start compression as shown in the fol-
lowing table:
Setting Values for Starting Density of High-Density Field
3
Set the DEP WEIGHT parameter of the High-Density Field
Touch the or button, and set the value within the range between 0 to 20.
The value on the left is the setting saved previously, and the value on the right is the cur-
rent setting.
The value indicates the compression ratio in the density area that is larger than the value
of STARTING DENSITY.
Select a larger value for higher degree of compression, and select a smaller value for
lower degree of compression.
Setting value 01234567891011121314
Starting density (D) 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.2 1.3 1.4 1.5 1.6
Setting value 15161718192021222324252627282930
Starting density (D) 1.7 1.8 1.9 2.0 2.1 2.2 2.3 2.4 2.5 2.6 2.7 2.8 2.9 3.0 3.1 3.2