Filter
Top Products
2.Edit Exposure Mode Settings
– 12 –
2
Set the STARTING DENSITY parameter of the Low-Density Field
Touch the or button, and set the value within the range between 0 to 30.
If the parameters of the High-Density Field are effective, this value cannot be set lower
than the value of STARTING DENSITY of the High-Density Field (→ P.10).
The value on the left is the setting saved previously, and the value on the right is the cur-
rent setting.
The value indicates the upper limit of density to start compression as shown in the fol-
lowing table:
Setting Values for Starting Density of Low-Density Field
3
Set the DEP WEIGHT parameters of the Low-Density Field
Touch the or button, and set the value within the range between 0 to 20.
The value on the left is the setting saved previously, and the value on the right is the cur-
rent setting.
The value indicates the compression ratio in the density area that is smaller than the
value of STARTING DENSITY.
Select a larger value for higher degree of compression, and select a smaller value for
lower degree of compression.
4
Set the DEP EFFECT parameter of the Low-Density Field
Touch the or button, and set the value within the range between 0 to 10.
The value on the left is the setting saved previously, and the value on the right is the cur-
rent setting.
The value indicates the intensity of restoration in high frequency component that reflects
the starting density and compression ratio of the Low-Density Field.
Select a larger value for higher degree of intensity, and select a smaller value for lower
degree of intensity.
NOTE: If the DEP EFFECT parameter is set to an excessive value, artifacts may
occur in the image, or the effective data of the exposure image may be dam-
aged.
Check the exposure image, and if the results of compression appear to be too
strong, either set the parameter to a smaller value, or set the DWT DEP not
effective.
Setting value 01234567891011121314
Starting density (D) 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.2 1.3 1.4 1.5 1.6
Setting value 15161718192021222324252627282930
Starting density (D) 1.7 1.8 1.9 2.0 2.1 2.2 2.3 2.4 2.5 2.6 2.7 2.8 2.9 3.0 3.1 3.2