Filter
Top Products
93
SHOOTING A MOVIE
4. Press the shutter button again to stop
shooting.
Each movie can be up to 10 minutes long. Movie recording
stops automatically after 10 minutes of recording. Movie
recording also will stop automatically if memory becomes
full before you stop movie recording by pressing the shutter
button.
Anti Shake Movie Recording
Turning on Anti Shake for movie recording causes the view
angle to become smaller. Anti Shake reduces the effects of hand
movement only. It does not limit the effects of subject movement
(page 102).
Movie Recording Precautions
• You cannot use flash while shooting a movie.
• The camera also records audio.
Note the following points when
shooting a movie.
– Take care that the microphone
is not blocked by your fingers,
etc.
– Good results are not possible
when the camera is too far
away from what you are trying to record.
– Operating camera buttons while shooting can cause button
noise to be picked up in the audio.
• Shooting a very bright subject can cause a vertical band to
appear in the monitor screen image. This does not indicate
malfunction. The band will be recorded in the case of a movie.
• Certain types of memory cards take longer to record data,
which can cause movie frames to be dropped. “ ” and
“ ” flash on the monitor screen during recording to let you
know when a frame has been dropped. Use of a memory card
with a maximum transfer speed of at least 10MB per second
is recommended.
Microphone