Filter
Top Products
50
Note: Only cameras on your local area network can be located using Browse
in IPView Lite. If you want to add a camera via the Internet, you must enter in
a physical IP Address. Remember that if your camera is behind a router, you
will need to enter your router’s WAN IP followed by a colon, then the port number
that is assigned to your camera, i.e. 10.10.10.80:800, where 10.10.10.80 is
your router’s WAN IP and :800 is the port that your camera is using. Please
refer to the DCS-900W Configuration, Installation Behind a Router section of
this manual for details on P.27.
How to Add a Camera
To add a new camera select Camera > Add from the IPView Lite. An Add Camera
dialog box will appear. (See below.)
Enter the IP Address of the camera in the specified field and click Add. If the IP Address
is entered incorrectly or if you have a bad network connection, a dialog box will appear
to notify you of the error. To add cameras in IPView Lite, check that you have your
network configured correctly. To add a remote camera, you need to have Internet access.
If you are unsure of the IP Address of the camera, you can click on Browse to search
for cameras on your local area network. The Browse Camera dialog box will appear
with a blank screen. (See below.)
IPView Lite (continued)