Filter
Top Products
EPN3600
26
Password: Input the password if the SMTP server requires authentication.
Receiver Address: Input the e-mail address for receiving e-mail message
when the EVENT is enabled and triggered. Please use “;” to separate
addresses.
Sender Address: Input sender’s e-mail address, so that receiver can
recognize the sender when an event message is sent out.
Send Test Mail: Click
button to send a testing mail to the
assigned address.
Set FTP
The settings relating to the FTP server used to transmit the alarm images
can be configured here.
FTP Server: Enter the IP address or the host name of the FTP server.
FTP Port: Enter the port number for FTP server. Default is 21.
Recording Path: Assign the recording path.
User Name: Set FTP User’s name.
Password: Set FTP password.
PASV mode: Check to enable Passive mode. Normally enable Passive
mode. When failed to establish the connection, uncheck "PASV" mode.
Test FTP Server: Click
button to send a testing file to the
assigned FTP server.
Click Apply to apply the setting changes or Reset to reset without saving
the change.