FujiFilm 4900 Digital Camera User Manual


 
99
5
SETTING THE FILE SIZE AND QUALITY
(
COMPRESSION RATIO
)
98
2
:
SET
-
UP MODE
Set the Mode switch to 0.
Set the Mode dial to 2 to display the
SET-UP screen.
Press a or b to select a setting.
Use d or c to change the settings.
1 2
Use a or b to change the file size setting
and d or c to change the quality setting.
Press the MENU/OK button to confirm the
setting.
!
There are 9 combinations of file size and quality
settings in total (P.27).
!
Images can be resized after shooting (P.80).
!
Always switch the camera off when you are
replacing the batteries. If you open the battery cover
or disconnect the AC power adapter without
switching the camera off, all the camera settings
may revert to the factory default values.
!
For FILE SIZE/QUALITY, DATE/TIME and
RESET ALL, press the MENU/OK button.
Use no compression
[
HI
]
or a low compression ratio
[
FINE or NORMAL
]
with the largest possible file
size setting. However, because this increases the
amount of data in each frame, the remaining
number of available frames is reduced.
To
p
roduce hi
g
h-
q
ualit
y p
rints
These images are intended to be viewed on a
personal computer screen, so you should use a
small file size
[
640
480
]
. Because this reduces the
amount of data in each frame, the remaining
number of available frames is increased.
For use on the Internet
Select
HI
or
FINE
for better image quality and
BASIC
to increase the number of available shots.
In most cases, the
NORMAL
setting provides
more than adequate image quality.
Qualit
y(
compression ratio
)
When the mode switch is set to 0 (excluding
.), holding down SHIFT and pressing
M
switches you to the settings screen.
You can select any combination of 3 file size
settings and 4 quality (compression ratio) settings
according to the type of shot you want to take.